66
2.3.1) Memorizing SRCW 06T as the first transmitter
When the code memory of the automation does not yet contain any codes, you can enter SRCW 06T following the
procedure described below:
Table 5
Abandoning the “manual” mode:
Example
After sending a command, press key
▼
.
Or:
Press key
■
repeatedly a number of times until
Auto
starts flashing.
Or:
Make sure that no group has been selected then press one of the following
keys:
▼
■ ▼
(if necessary, select the groups by pressing key
▼
and deselect / select
them by pressing key
▼
).
!
Warning:
the code can be memorized in all the receivers found within the range of SRCW 06T; you should there-
fore keep within range only the one involved in this operation.
All the memorization sequences are timed, which means that they must be executed within the set time limits.
3s
Table 6
Memorizing SRCW 06T as the first transmitter
Example
1.
On SRCW 06T, select the group in which you wish to memorize the
automation, using the manual mode (Table 2).
2.
Power the automation, you will immediately hear 2 long beeps **.
3.
Within 5 seconds, press and hold down key
■
on SRCW 06T
(for approx. 3 seconds).
4.
Release
key
■
when you hear the first of the 3 beeps confirming the
memorization.
** If the memory of the automation already contains codes, when the unit is powered you will hear 2 short beeps; in
this case you must follow the instructions provided in the table below.
5s
2.3.2) Memorizing SRCW 06T as an additional transmitter
If the code memory of the automation already contains other transmitter codes, you can enter SRCW 06T following
the procedure described below.
Table 7
Memorizing SRCW 06T as an additional transmitter
Example
1.
On SRCW 06T, select the group in which you wish to memorize the
automation, using the manual mode (Table 2).
2.
Press and hold down key
■
on SRCW 06T until you hear a beep coming form
the automation (after approx. 5 seconds).
3.
Press
key
■
on a previously memorized and operational transmitter 3 times
slowly.
4.
Press
key
■
on SRCW 06T once more.
Finally, 3 beeps coming from the automation will confirm that SRCW 06T has been correctly memorized.
If the code memory is full (14 codes), 6 beeps will warn you that SRCW 06T cannot be memorized.
... Auto
www.stobag.com
SKIMY_SRCW_06T.indd 66
SKIMY_SRCW_06T.indd 66
1.3.2010 11:07:33 Uhr
1.3.2010 11:07:33 Uhr
