Still RX70-20/600, Original Instructions Manual, Page: 379 / 432

The cooling fluid level is monitored by a sen-
sor. As soon as the
COOLANT LEVEL
mes-
sage appears on the display, proceed as de-
scribed below:
–
Switch off the engine and let it cool down.
–
Remove the rear cover.
–
Slowly open the filler cap (1) of the cooling
fluid tank (5) and release the excess pres-
sure.
–
Unscrew further and remove the filler cap.
–
Check the cooling fluid level.
The cooling fluid level must be between (3)
the upper marking (2) and the lower mark-
ing (4), at an equal distance from each mark-
ing.
–
Top up the cooling fluid to no higher than
the upper marking, if necessary.
–
Make sure that the tank cap (1) is screwed
on and is tightly sealed.
–
Check the leak tightness of the cooling sys-
tem; see the section entitled "Cleaning the
radiator, checking for leaks".
–
Replace the rear cover.
Topping up the cooling fluid and
checking the coolant concentration
WARNING
Risk of scalding due to hot cooling fluid!
The cooling system is pressurised! Cooling fluid may
escape if the cooling fluid tank (5) is opened while
the engine is hot.
–
Switch off the engine and allow it to cool down be-
fore opening the filler cap (1).
WARNING
Coolant and cooling fluid can pose a hazard to health
and the environment!
–
Observe the safety regulations set out in the sec-
tion entitled "Coolant and cooling fluid".
1
2
3
4
II
II
5

1
2
3
4
II
II
5

Maintenance
5
Preserving operational readiness
365 57368011501 EN - 10/2020 - 04