Still RX70-20/600, Original Instructions Manual, Page: 208 / 432

Controlling the lifting system using a
triple mini-lever
DANGER
Reaching into or climbing between moving parts of
the truck (e.g. lift mast, sideshifts, working equip-
ment, load carrying devices etc.) can lead to seri-
ous injury or death and is therefore prohibited.
–
Observe the safety regulations for handling loads.
–
Operate the lifting system from the driver's seat
only.
The lifting, lowering and tilting movements of
the lift mast are controlled using the "lift
mast" 360° lever (3). The adhesive label bear-
ing the pictograms for the hydraulic func-
tions (1) or (2) is affixed at the designated
point (4).
–
If the adhesive label becomes illegible or is
missing, please contact your authorised
service centre.
–
Observe the pictograms on the adhesive la-
bels (1) and (2).
The pictograms are arranged according to the
direction of movement of the "lift mast" 360°
lever (3).
NOTE
The truck is configured at the factory in ac-
cordance with the adhesive label (1). The fol-
lowing steps for moving the fork carriage and
lift mast are based on this configuration.
Lifting/lowering the fork carriage
To lift the fork carriage:
–
Move the "lift mast" 360° lever (3) in the di-
rection of the arrow (B).
To lower the fork carriage:
–
Move the "lift mast" 360° lever (3) in the di-
rection of the arrow (A).
Tilting the lift mast
To tilt the lift mast forwards:
D C
B
A
A B
C
D

Operation
4
Lifting
194 57368011501 EN - 10/2020 - 04