Still RX20 14-20, Original Instructions Manual

Page: 234 / 600

NOTE
If the truck is equipped with the "load meas-
urement" assistance system (variant), the
"tare" function must always be run after the
fork arms have been changed. Otherwise, cor-
rect load measurement cannot be guaranteed.
Attaching
DANGER
Risk of fatal injury from falling load!
At least 60% of the length of the fork extension must
lie on the fork arm. No more than 40% of the length
of the fork extension may overhang the end of the
fork arms. In addition, the fork extension must be
secured against slipping from the fork arm.
If the fork extension (1) is not secured with a secur-
ing bolt (2) and linch pin (3), the load may fall, along
with the fork extension.
–
Push the fork extension all the way to the back of
the fork.
–
Make sure that 60% of the length of the fork ex-
tension is on the fork arm.
–
Always secure the fork extension with the secur-
ing bolt.
–
Always secure the securing bolt with the linch pin.
–
Remove the linch pin (3) from the securing
bolt (2).
–
Remove the securing bolt from the fork ex-
tension (1).
–
Push the fork extension onto the fork arms
until the fork extension is flush with the fork
back.
–
Insert the securing bolt located behind the
fork back fully into the fork extension.
–
Insert the linch pin into the securing bolt
and secure.
Detaching
–
Remove the linch pin (3) from the securing
bolt (2).
–
Remove the securing bolt from the fork ex-
tension (1).
–
Pull the fork extension off the fork arms.
7071_003-104_V2
1
2
3

Operating
4
Lifting
218 56368011501 EN - 04/2022 - 13