EN
25
0478 131 8349 A - EN
Set the current time using the
control pad and confirm with the OK
button.
9.9 Installing the docking station
●
Connect the power cable to the docking
station. (
●
Route the power cable under the floor
plate when the docking station is
installed at a wall. (
Fix the docking station (B) into position at
the chosen location using four pegs (H).
●
Install the power supply unit outside the
mowing area, protected from direct
sunlight, humidity and moisture – fasten
to a wall if necessary.
●
Route all power cables outside the
mowing area, in particular out of reach
of the mowing blade, and fasten them to
the ground or accommodate in a cable
duct.
●
Unreel power cables in the vicinity of
the docking station in order to avoid
interference with the wire signal.
●
Connect the mains plug.
●
After completing this installation
work, press the OK button on the
control panel.
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
Read the "Notes on the docking
station" section (
the installation examples (
this instruction manual.
Correct operation of the power
supply unit is only ensured at an
ambient temperature
between
0° C
and
40° C
.
The red LED on the docking station
flashes rapidly as long as no
perimeter wire is connected.
(
With external docking station:
Define at least one starting point
outside the corridor to the docking
station after initial installation is
complete. Define the starting
frequency so that 0 of 10 mowing
operations (0/10) are started at the
docking station (starting point 0).
(
