Stihl RM 4 R, Instruction Manual

Page: 41 / 400

39
DE
FR
NL
IT
ES
PT
NO
SV
FI
DA
PL
HU
HR
CS
EN
0478 111 9935 B - EN
7. 1 General
● Place the machine on level and firm
ground when performing all the
operations described.
7.2 Assembling the handlebar
(RM 4 R, RM 4 RT, RM 4 RV)
● Fit protective sleeves (E) onto
upper handlebar (1) with the long side
facing inwards.
● Hold upper handlebar (1) on lower
handlebar (2) and insert screws (C)
through bores (3) from the inside
outwards.
● Screw in quick-clamping device (D) at
screws (C) (it should project by about
one screw thread turn) and fold
upwards.
● Check correct assembly:
Quick-clamping devices (D) must be
sufficiently tightened so that they are
pressed tightly against the handlebar
and the upper handlebar is firmly
connected to the lower handlebar.
If the handlebar is not firmly installed or
the quick-clamping devices are not
correctly located, fold open the quick
clamping devices and adjust them to
the correct position by screwing out and
in.
7.3 Assembling the handlebar
(RM 4 RTP)
● Fit protective sleeves (I) onto
upper handlebar (1) with the long side
facing inwards.
RM 4 RTP:
Start the engine.
RM 4 R, RM 4 RT,
RM 4 RV:
Stop the engine.
RM 4 RTP:
Stop the engine.
RM 4 RT, RM 4 RV:
Switch on self-propulsion.
RM 4 RTP:
Switch on self-propulsion.
RM 4 RV:
Set the driving speed.
(
Ö 11.3)
RM 4 RTP:
Wear hearing protection
when working.
Service position marking on
the detent segment.
(
Ö 12.1)
6. Standard equipment
Item Designation Qty.
A Basic unit with handlebar 1
−
Instruction manual 1
−
Engine instruction manual 1
RM 4 R, RM 4 RT, RM 4 RV:
B
Cable clips 2
C Flat head bolts 2
D Quick-clamping devices 2
E Protective sleeves 2
RM 4 RTP:
B
Cable clips 2
F Flat head bolts 2
G Retaining washers 2
H Lock nuts 2
I Protective sleeves 2
7. Preparing the machine for
operation
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
Ö 4.).
2
3
4