53
MS 360 C
english / USA
:
Hold the file
horizontally
for all
chain types (at right angle to side of
guide bar) and file according to the
angles marked on the filing tool.
:
Avoid touching the tie straps and
drive links with the file.
:
Rotate the file at regular intervals
while filing to avoid one-sided wear.
:
Use a piece of hardwood to remove
burrs from cutting edge.
:
Check angles with the filing gauge.
All cutters must be the same length
If the cutters are not the same length,
they will have different heights. This
makes the chain run roughly and can
cause it to break.
Find the shortest cutter and then file all
other cutters back to the same length.
This can be very time consuming – it is
best to have it done in the workshop on
an electric grinder.
Depth gauge setting
The depth gauge determines the height
at which the cutter enters the wood and
thus the thickness of the chip removed.
Specificed distance or setting between
depth gauge and cutting edge =
a:
This setting may be increased by 0.2mm
(0.008") for cutting softwood in mild
weather season – no frost.
Lowering depth gauges
The depth gauge setting is reduced
when the chain is sharpened. Use filing
gauge to check the setting every time
you sharpen the chain and, if necessary,
lower the depth gauge with a flat or
triangular file so that it is level with the
filing gauge.
Round off depth gauges parallel to the
stamped marking.
After sharpening
Clean the chain thoroughly, remove
filings or grinding dust – lubricate the
chain by immersing it in an oil bath.
Before long out-of-service period
Clean the chain with a brush and
immerse it in an oil bath.
Chain pitch
Depth gauge
setting “
a
“
Inch
(mm)
mm
(Inch)
1
/
4
(6.35)
0.65
(0.026)
3
/
8
PMN (9.32)
0.45
(0.018)
3
/
8
PM (9.32)
0.65
(0.026)
0.325
(8.25)
0.65
(0.026)
3
/
8
(9.32)
0.65
(0.026)
0.404
(10.26) 0.80
(0.031)
a
689BA023 KN
689BA024 KN
Summary of Contents for MS 360 C
Page 64: ...63 MS 360 C english USA...
Page 65: ...64 english USA MS 360 C...
Page 129: ...128 espa ol EE UU MS 360 C...
