42
english / USA
MS 360 C
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
:
Use the adjusting screw
(1)
(on
underside of machine) to vary the
oil feed rate as required.
:
For average oil feed rate, turn
adjusting screw to “
E
“
(
E
matic
position).
:
To increase oil feed – turn adjusting
screw clockwise.
:
To reduce oil feed – turn adjusting
screw counter-clockwise.
Your chain must always be wetted
with a film of lubricant.
:
Turn the bar over –
every time you sharpen the chain
and every time you replace the
chain – this helps avoid one-sided
wear, especially at the nose and
underside of the bar.
:
Regularly clean
the oil inlet hole
(1)
,
the oilway
(2)
and
the bar groove
(3)
.
:
Measure groove depth –
with scale on filing gauge* – in area
used most for cutting.
*
see “Guide to Using this Manual”
If groove depth is less than specified:
:
Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove
–
the cutters and tie straps will not ride on
the bar rails.
Oil Quantity
Control
176BA003 KN
1
Taking Care of Guide Bar
2
001BA119 KN
1
3
3
Chain
type
Pitch
Minimum
groove
depth
Picco
3/8“ P
0.20"
(5.0 mm)
Rapid
1/4“
0.16"
(4.0 mm)
Rapid
3/8“; 0.325“ 0.24"
(6.0 mm)
Rapid
0.404“
0.28"
(7.0 mm)
Summary of Contents for MS 360 C
Page 64: ...63 MS 360 C english USA...
Page 65: ...64 english USA MS 360 C...
Page 129: ...128 espa ol EE UU MS 360 C...
