49
MS 192 T
:
Fit the switch shaft (1), pushing
the rear contact spring (3) slightly
to the side.
Check operation:
The contact springs are fitted in the
handle housing at different depths.
This means that the rear contact
217RA166 TG
1
2
3
spring (3) and the front contact
spring (2) must make contact with
the metal pin of the switch shaft
when the switch shaft (1) is in
position "0".
– Reassemble parts in reverse
order.
– Set the air gap between ignition
coil and flywheel
– Reassemble remaining parts in
reverse order.
– Tightening torques,