Stihl FS 40, Service Manual

Page: 58 / 82

57 Series 4144 Components FC, FS, KM
:
Pull the throttle cable (1) out of
the guides (arrows).
– Remove the throttle trigger and
disconnect the throttle cable,
b
7.3.1
– Check the throttle cable and
replace if necessary.
– Fit throttle cable on throttle
trigger,
b
8.6
:
Push the throttle cable sleeve (1)
into the guide as far as stop.
The throttle cable sleeve must butt
against the stop (arrow).
545RA280 TG
1
545RA022 TG
545RA144 TG
1
– Position the throttle cable under
the tank vent hose (1).
:
Fit the throttle cable retainer (2) in
its seat (arrow).
:
Push the throttle cable (1) into the
guides in the engine housing
(arrows) as far as stop.
:
Tighten down the screw (1)
firmly.
– Install the carburetor,
b
8.2
545RA074 TG
1
2
545RA280 TG
1
545RA024 TG
1
– Turn the pin (1) until the slot is in
line with the throttle cable.
:
Press down the throttle lever (2).
– Fit throttle cable (1) in the pin's
(2) slot.
:
Turn the pin until the nipple is
properly seated (arrow).
– Check operation of throttle cable
and readjust if necessary,
b
8.6.2
– Reassemble all other parts in the
reverse sequence.
– Tightening torques,
b
3.4
545RA042 TG
1
2
545RA043 TG
2
1