Stihl ASA 85, Instruction Manual

Page: 20 / 224

0458-285-9721-C
18
English 13 Operating the Pruning Shears
► Switch on the pruning shears.
► Press the control lever (2) downwards as often as
necessary until the display (1) shows the required
information.
The data (A, C, D and E) can be reset.
► To reset the data displayed: Depress the control lever (2)
for 2 seconds.
The data displayed is reset.
The number of cuts that can be performed before the next
recommended service is due (A)
The display (1) shows the number of cuts that can be
performed before the next recommended service is due.
The display shows the battery’s state of charge after a few
seconds (B).
► If the number of cuts is 0: Press the control lever (2).
The display (1) shows the battery’s state of charge (B).
Battery's state of charge (B)
The display (1) shows the battery’s state of charge. Each bar
represents 10% of the battery's capacity
Number of cuts and operating time in hours and minutes (C)
The display (1) shows the number of cuts and operating time
in hours and minutes.
Number of cuts with low, medium and high force (D).
The display (1) shows the number of cuts with low, medium
and high force.
The control unit allocates each cut to the following classes:
– S = Number of cuts with low force
– M = Number of cuts with medium force
– L = Number of cuts with high force
Cutting blade blockages (E)
The display (1) shows the number of cutting blade
blockages.
13.3 Putting the Pruning Shears in Standby Mode
The pruning shears can be put in standby mode during short
work breaks.
► Pull the trigger (2) twice in quick succession and hold it
depressed on the second pull.
You will hear 3 short beeps. The cutting blade (1) closes
and remains closed.
► Release the trigger (2).
The pruning shears are in standby mode.
When you pull the trigger (2) again, the cutting blade (1)
opens and the pruning shears are ready for operation.
2
1
XX xxxxxx
# 123456 23h 45m
BATT: I I I I I I
A
B
C
D
E
42%S 37%M 21%L
xx XXL
0000-GXX-4331-A0
2
1
0000-GXX-4102-A0