15
ENGLISH
EN
1 GENERAL
This symbol indicates WARNING.
Personal injury and/or damage to
property may result if the instructions
are not followed carefully.
You must read these instructions and
the accompanying pamphlet “SAFETY
INSTRUCTIONS” carefully, before the
assembly begin.
2 ASSEMBLY
To avoid injury and damage to people
and property, do not use the machine
until all the measures in this instruction
have been carried out..
2.1 Accessories bag
The machine is supplied with a plastic bag
containing components which shall be used during
the assembly. The bag contains (fig. 1):
Pos. No. Designation
Dimension
A
1
Shim washer
16 x 38 x 0.5
B
1
Shim washer
16 x 38 x 1.0
C
1
Tension pin
6 x 36
D
1
Spare key
E
4
Screw
8 x 20
F
2
Shoulder washer
G
4
Washer
8.4 x 24 x 2.0
H
2
Knob
I
2
Screw (Royal)
J
1
Battery belt
K
1
Drawing plate
2.2 References
The figures in these instructions for use are
numbered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component C in figure 2 is written
“2:C”.
2.3 Engine casing (2:M)
To inspect and maintain the engine and battery,
remove the engine casing.
The motor must not be
running when the casing is removed.
Dismantling:
1. Fold up both casing locks at the rear edge (2:L).
2. Pull the engine casing back a little first. Then lift
it off.
Assembly:
1. Fold the seat forward.
2. Align the casing’s upper, front pins with the
slots in the front engine casing (fig. 3). Leave
approx. 2 cm clearance.
3. Guide both conical side pins into the holes in the
front engine casing. Then press the entire casing
forwards.
5. Finally fold down both casing locks (2:L).
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.
2.4 Battery
Never overcharge the battery. Over-
charging can damage the battery.
Do not short-circuit the battery’s termi-
nals. Sparks occur which can result in
fire. Do not wear metal jewellery which
can come into contact with the battery
terminals.
In the event of damage to the battery casing,
cover, terminals or interference to the strip cov-
ering the valves, the battery should be replaced.
The battery is a valve-regulated battery with 12 V
nominal voltage. The battery fluid does not need to
and cannot be checked or topped up. The only
maintenance that is required is charging, for exam-
ple after extended storage.
The battery must be fully charged be-
fore being used for the first time. The
battery must always be stored fully
charged. If the battery is stored while
discharged, serious damage will occur.
2.4.1 Charging with the engine
The battery can be charged using the engine’s gen-
erator as follows:
1. Install the battery in the machine as shown be-
low.
2. Place the machine outdoors or install an extrac-
tion device for the exhaust fumes.
3. Start the engine according to the instructions in
the user guide.
4. Allow the engine to run continuously for 45
minutes.
5. Stop the engine. The battery will now be fully
charged.
2.4.2 Charging using battery charger
When charging using a battery charger, a battery
charger with constant voltage must be used.
Contact your dealer to purchase a battery charger
with constant voltage.
The battery can be damaged if a standard type
battery charger is used.