WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
Record the reading on the adjuster (10) (this must
be reset at reassembly to give a preliminary belt ad-
justment) and slacken it off completely.
Dismantle the pin (11), slacken off the fixing nuts of
the three pins (12) and the pulleys (13) and (14) to al-
low removal of the belt.
Set the cutting deck to the lowest position to obtain
greater access, then slacken off and uncouple the ad-
juster (1) to unload the spring (2) .
Dismantle the upper casing (3), undo screw (4) and
di smantle the control pulley (5); undo the articulation
screw (6) and remove the stretcher plate (7).
Remove the protection casing (8), slackening off the
six surround screws (9) and extract it from its slots.
Validity
General informations
Related topics
Special tools
Adjusting the engagement and checking
the blade brake
Belts assembly
Tightening torques
4
Blade pulley screws ....................... 20 ÷ 25 Nm
6
Stretcher plate articulation screw ... 35 ÷ 40 Nm
11-12
Pin fixing nuts ......................... 30 ÷ 35 Nm
13-14
Pulley fixing nuts ..................... 30 ÷ 35 Nm
REPLACEMENT OF THE
BLADES CONNECTION BELT
CHAPTER
REVISION
FROM ...
PAGE
6.7
0
2018
1 of 2
