WORKSHOP MANUAL
T...102/122 - TC...102/122
Reattach the accelerator cable and ...
Adjust the «MINIMUM» position.
Refit the front hood.
Re set the adjuster (1) and check the spring ten-
sion.
Identify and undo all the screws that fasten the
engine to the chassis, then carefully lift and remove
the engine using equipment suitable for the weight of
the engine (about 35-45 kg) and the designated lifting
points to guarantee safe working conditions.
NOTE
Some engines are held with screws of differ
ent length and in different positions, so it is best to
label them so that no errors are made on reassembly.
On reassembly, fully tighten the screws for the en gi ne
and the pulley to the amounts shown.
Reassemble the spacer (9), with the countersink fac-
ing the engine. En su re that the pin (11) is inserted into
the clutch spli ne (7) and remember to refit the spring
(6).
Remember to fit the clamps back on the fuel
pipe and check that it does not leak.
Reattach all the electrical and earth contacts and refit
the protection covers.
Reset the stret cher spring tension should it have been
slacke ned.
REMOVAL OF THE ENGINE
CHAPTER
REVISION
FROM ...
PAGE
5.5
1
2018
2 of 2
