WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
B) Removing the front cover
Remove the dashboard [see point “A”].
Remove the parking brake lever knob (11) or (12) and
dismantle the front guard (13) fixed to the chassis by
six screws (14).
A) Removing the dashboard
Use a 5 mm diameter round bar to remove the pin (1)
and take out the steering wheel (2).
Disconnect the end of the accelerator cable from the
engine and disconnect all electrical connections and
the starter cable (where fitted).
At this point it is possible to remove the dashboard,
which is fixed to the frame by four self-threading
screws (3) and (4).
NOTE
The screws (3) are covered by pla stic caps on
some models.
On reassembly, on
some models, the di-
rection of the springs
(5) must be adjusted
in relation to the po-
sition of the hood, to
ensure fastening.
Validity
General informations
The dashboard is removed to make the following
mo re accessible:
– the accelerator;
– the ignition block,
– various electrical components.
With some drives it could be necessary to re
move the dashboard before it is possible to dis
mantle the fuel tank.
Related topics
---
REMOVING THE DASHBOARD
AND FRONT COVER
CHAPTER
REVISION
FROM ...
PAGE
5.4
0
2018
1 of 1
