WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
The cover (8) is fixed by two screws (9) located un der
the side footboards and four screws (10) fixing it to the
rear plate.
The cover (8) can be
removed after the cut-
ting height adjustment
lever has been set to its
highest position.
Remove the spring (1) fixing the battery, ensuring
that accidental short circuits are not caused; first di-
sconnect the black cables (earth), then the red ca ble
(positive) and remove the battery (2).
Remove the caps (5) from the springs and undo the
screws inside (6).
Remove the seat after having dismantled the two pins
(7).
Validity
General informations
Removing the wheel cover gives access to:
– the mount for the lever to raise the deck;
– the supports of the footboards.
Related topics
---
Tightening torques
9
Lower cover fixing screw ...............4,0 ÷ 4,5 Nm
10
Upper cover fixing screw ............ 4,0 ÷ 4,5 Nm
REMOVAL OF THE WHEEL COVER
CHAPTER
REVISION
FROM ...
PAGE
5.2a
1
2018
1 of 2
