WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
Toothed sectors (10) are secured to the ring gear (5)
by screws and nuts (11).
When replacing, be careful to assemble sectors with
the flared part of the teeth facing down.
Check ring gear allowance (5) compared to the pin
(12); if excessive, replace the bearing.
Unscrew the three nuts (13), remove the support (14)
and slide out the bearing (15) to replace.
Unhook the spring (1) and lift the steering column (2)
just enough to be able to draw out the pinion (3).
A) Dismantling the steering pinion and ring gear
Remove the tie-rod (6), unscrew the nut (4) and take
out the whole ring gear shaft (5) being careful not to
lose the washers (7) and (8) under the screw head (9).
Validity
General informations
Related topics
Steering geometry adjustment
Tightening torques
4
Nut for Ring gear .............................45 ÷ 50 Nm
11
Nuts for toothed sector fastening ..10 ÷ 15 Nm
13
Nuts for bearing fastening ...............25 ÷ 30 Nm
DISMANTLING OF THE STEERING
COMPONENTS
CHAPTER
REVISION
FROM ...
PAGE
6.3
0
2018
1 of 2
