INSTRUCTION MANUAL
GB
–
6/6
- DOC NO. BE0455020-A
CONTROL & PERIODIC MAINTENANCE
1) To ensure the functional integrity of the VIGIBELT
®
CDM80, you must schedule periodic inspections. The
frequency of inspections must be sufficient to avoid dangerous situations (situations that affect the intrinsic
functioning of the VIGIBELT
®
CDM80).
2) During these inspections, check that the VIGIBELT
®
CDM80 are not affected by the following defects: dust layer
>2mm, dust leakage between the sheath of the elevator and the VIGIBELT
®
CDM80, non-operational power-on LED,
degraded electrical wiring, shocks on the envelope of the VIGIBELT
®
CDM80, etc...
3) In the case of one or more defects found, you must proceed with the restoration in order to correct the defect(s)
before you can use the bucket lift or belt conveyor again.
4) Only personnel trained and authorized in maintenance procedures for these equipments are able to carry out
inspections for the VIGIBELT
®
CDM80.
DISPOSAL
When dismantling the VIGIBELT
®
CDM80, the user must ensure the proper disposal of this device and hand over
to the specialized harvesting centers the components according to their nature (stainless steel, electrical
equipment, seal, etc.).
In the event that the VIGIBELT
®
CDM80 kit is used, controlled, under conditions contrary to the precautions
described in this instruction manual, STIF declines all responsibility for damage caused to man, animal,
environment, material property.
