26
Assembly collectors
The previously inserted collector fastening plate “double“ is
introduced to the stop position on the collector. Then the T-head
screw is fixed lightly with the washer and the nut M8.
To guarantee the mounting measure the T-head screw of the
fastening plate has to be located on the joining point of the fastening
profiles.
Placement of the first collector.
Place the collector on the upper profile rail and put it down on the
lower one.
Make sure that the back panel of the collector is not damaged by
any protruding parts.
The collector is applied to the profile of the collector stop set.
The stop set profile has to be mounted so that it can be fixed
indented maximal 20 cm from the outer edge of the collector.
The fastening plate “single“ is inserted and fixed on the outside of
the collector.
Tighten the fasteners after having mounted the hydraulic collector
connections (see page 27).
1400020 Collector fastening set profile edge FKA
1400021 Collector fastening set profile FKA
Summary of Contents for FKA 240 Series
Page 1: ...1 Assembly Instructions Solar collectors FKA 240 270 Roof mounted installation...
Page 36: ...36 Initial operation 0 1 2 3 4 2 5 3 6 7 8 9 6 1 0 3 1 6 2 3 6 6 5 5...
Page 37: ...37 Initial operation Schematic drawing of the system construction and piping scheme...
Page 38: ...38 Initial operation Notes...
