20
Assembly mounting profiles
Readily mounted tile clamps for one collector field with two collec-
tors.
Top: Tiles left out and clamp set with mounting tabs assembled
Bottom: Tiles coarsly ground and clamps assembled without
mounting tabs
Place the T-head screws laterally into the profile into any groove.
1400026 Profile set Alu 240V and 270V or
1400027 Profile set Alu 240H or
1400028 Profile set Alu 270H
1400024 Fastening set for profile set on roof hooks (4 fast. pts.)
for every additional collector in one row
1400023 Fastening set for profile set on roof hooks (2 fast. pts.)
Fix the T-head screw with the washer and the nut after putting it
through the slot.
Do not exceed the T-head screw‘s tightening torque of 27 Nm.
The slots in the hooks are for evening out bumps. The fastening of
the profile must be realised in the upper third of the slot.
At an angle of 90° to the T-head screw the stop sets are put into
the groove; protruding side up. For each collector there are two 5
cm long stop profiles. The fixation is effected, each time indented
maximal 20 cm from the end of the collector.
Only in the lowest row the stop profiles are supplied and assembled.
1400025 Stop set for profile set
Dachhaken
Summary of Contents for FKA 240 Series
Page 1: ...1 Assembly Instructions Solar collectors FKA 240 270 Roof mounted installation...
Page 36: ...36 Initial operation 0 1 2 3 4 2 5 3 6 7 8 9 6 1 0 3 1 6 2 3 6 6 5 5...
Page 37: ...37 Initial operation Schematic drawing of the system construction and piping scheme...
Page 38: ...38 Initial operation Notes...
