Stewart Filmscreen
– Visionary
7
PREPARING THE INSTALLATION (CONTINUED)
Note:
Bolts and other fasteners for the screen are standard gauges and sizes used in the U.S.,
regardless of the installation country. For this reason, sizes are expressed in inches rather than
metric measurements.
Unpacking
Be sure to unpack carefully in a clean area. Use special care when handling the screen so that it
does not become soiled or damaged. If you plan to repack your screen and hardware for
transportation to another location, you may want to photograph or make a note of how it was
packed. Retain the packing material for future use, if desired.
Remove the outer plastic covering and white
wrapping paper surrounding the screen case.
Do not remove the wrapping paper surrounding the
screen roller. You should remove it only after the
unit is hung and all electrical connections have
been made.
Removing the screen assembly from the case
The unit is shipped with the screen assembly
fastened inside. Prior to mounting the unit, you
must remove the screen assembly from the case.
Using the supplied wrench, loosen the bolts shown
in Figure 1. There is a bolt inside each end of the
screen slot.
⚠
CAUTION
Do not stand on the screen case or store it on its end. This will cause screen damage. If
you are not going to install the screen immediately, make sure it remains horizontal
during storage.
Note: Failure to comply with the instructions and guidance
contained in this manual may result in voiding your warranty.
Supplied Wrench
Figure 1.
Visionary bottom view,
removing bolt holding screen assembly
