Final Assembly Continued
136. Mount a prop adaptor suitable to your motor. If using the recommended
motor [SA Sport A2212-6], we recommend using either the E-Flite
EFLM-1930 or EFLM-1923 for 1/8 in. shafts.
137. Ream out the hole in the propellor [GWS0804] to fit your adaptor - in the
case of the EFLM-1930 or -1923 this will be 1/4 in.
138. Mount the propellor securely to the prop adaptor with the retaining nut.
139. Affix the vinyl peel and stick color pilot profiles to the balsa pilot outline P.
Note: Pilot figure may vary from illustration.
140. Fit the pilot to the slot in F1 within the cockpit and bond with thin CA.
141. Secure the wing to the fuselage with four #32 rubber bands. Always use
fresh rubber bands before each flying session!
Wala! Your Stevens Aero BUZZ 400™ is finished!
Set it on the coffee table and
admire it until the wife tells you to get it out of there.
We hope you enjoyed building your
BUZZ 400™.
Proceed to the Setup and Pre-Flight
sections of this manual to prepare your
BUZZ 400™
for flight.
Build Instructions April 15, 2014
!
(c) 2011 Stevens AeroModel all rights reserved.
!
Page 43
☐
☐
☐
☐
☐
☐
