Final Assembly
(continued)
Push Rods and Receiver
6.
Refer to the
Push Rod Detail
drawing on the
Detail Sheet 2 of 2.
Make a “snake” bend at
one end of each of the .015 in. wires supplied in the kit.
7.
Connect the “snake” bends to the servo tabs on the receiver brick.
Note: The holes on the
servo tabs are different sizes.
Insert the pushrods into the
middle
hole of the servo tabs.
8.
Refer to the
Push Rod Detail
drawing on
Detail Sheet 2 of 2
. Feed the push rods through
the fuselage and out through the exit slots in the fuselage sides. Fit the receiver brick to the
receiver tray by first slipping the
rear
of the circuit board into the notch in the short arm of
the clip. Press
down
on the
front
of the circuit board until it snaps under the long arm of the
receiver clip.
9.
Cover the
bottom
of the fuselage.
Motor
10.
Remove the spikes from the
bottom
of the mounting tabs on the recommended motor/
gearbox (PKZ3624). Sand the tabs smooth.
11.
Using a sharp razor blade or hobby knife, shave off the humps on the
top
of the mounting
tabs on the gear box. Sand the tabs smooth.
Build Instructions
1928 Pietenpol Sky Scout UM
- Build Instructions © 2015 Stevens AeroModel, all rights reserved.
!
Page 20
□
□
□
□
□
□