6
| STERO SD3 DOOR-TYPE DISHWASHER
INSTALLATION
(continued)
RACK TRACK
GUIDE RAIL
WASH TANK
DISH TABLE
DISH TABLE
CORNER OPERATION SHOWN
DISH TABLE
INNER WALL OF
WASH TANK
SEALANT
MACHINE SCREW
OR RIVET
NUT
CONTROLS MUST BE ACCESSIBLE AT
FRONT CORNER.
CORNER INSTALLATION
Before placing the dishwasher in its operating location, check machine configuration. If the machine is being
installed in a corner (Figure 4), clearances of 20" out from the dishwasher under the left-hand tabling by 27"
above the finished floor and 15" out from the dishwasher at the right side by 27" above the finished floor must
be provided for servicing. For proper installation of a corner machine, the control and display should be posi-
tioned at the front corner for operator access (Figure 4).
For corner installation, rotate the rack track so the guide rail is positioned on the left side (Figure 5). For corner
machines, remove the front door deflector (unscrew three bolts / nuts).
Figure 4
Figure 5
For corner installations, tabling with backsplashes over
6" high require that a notch be provided to prevent
interference with the door mechanism (Figure 6).
A NOTCH MUST BE ADDED TO BACKSPLASHES
OVER 6" HIGH ON CORNER MACHINES TO PREVENT
INTERFERENCE WITH DOOR MECHANISM. NOTCH
MUST EXTEND 6" FROM FACE OF THE MACHINE.
Figure 6
6.000
6.000
