STERO SD3 DOOR-TYPE DISHWASHER |
5
UNPACKING
Immediately after unpacking the dishwasher, check for possible shipping damage. If this machine is found to
be damaged, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installation, test the electrical service to make sure it agrees with the specifications on the machine
data plate; this includes the optional electric booster, if equipped. The dishwasher data plate is located at the
bottom of the front panel.
INSTALLATION CODES
Installation must be in accordance with state and local codes, or in the absence of local codes, with the
National Electrical Code ANSI/NFPA 70 (latest edition). In Canada, the installation standard is: CSA C22.2 No. 1
(latest editions).
LOCATION
Before finalizing the location, make sure that consideration has been given for the electrical conduit, water
supply, drain connection, venting (if applicable), tabling (if needed), chemical feeder replenishment (if applica-
ble) and adequate clearance for opening the door.
The dishwasher must be level before any connections are made. Turn the threaded feet (Figure 2) as required
to level the machine and adjust to the desired height.
The edge of the dish table that overhangs the SD3 wash tank should be turned down and fitted over the top
of the dishwasher tank (Figure 3). Apply an NSF approved sealant between the overhang of the dish table and
the inner wall of the wash tank to prevent leakage (Figure 3). Fasten the dish tables to the inner wall of the
wash tank with non-rusting truss head screws or rivets (Figure 3).
For straight-through installations, clearance at the front and 15 inches out from the dishwasher at the right
side by 27 inches above the finished floor must be provided for servicing.
INSTALLATION
Figure 2
WASH TANK
DISH TABLE
DISH TABLE
STRAIGHT-THROUGH OPERATION SHOWN
INNER WALL OF
WASH TANK
SEALANT
NUT
DISH TABLE
MACHINE SCREW
OR RIVET
Figure 3
MACHINE LEG
ADJUSTABLE FOOT
