Steris AL-1000, Maintenance Manual

Page: 2 / 35

AL ‐ 1000 Installation ‐ Operation ‐ Service Manual P764333 ‐ 823 December 18, 2009
1
STERIS AL ‐ 1000 Installation ‐ Operation ‐ Service Manual
SAFETY SYMBOLS
Familiarize yourself with the meaning of each
Safety symbol appearing either on the unit or in
the instruction manual.
GENERAL CAUTION: Indicates a general
safety caution.
SHOCK HAZARD: Indicates that hazardous
voltages inside the enclosure.
READ MANUAL: Indicates to read the manual for
important instructions and procedures related to
safety.
CAUTION: Wear protective clothing and eyewear when dispensing chemicals or
other materials. Observe safety handling instructions (MSDS) of chemical mfrs.
CAUTION: To avoid severe or fatal shock, always disconnect main power when
servicing the unit.
CAUTION: When installing any equipment, ensure that all national and local
safety, electrical, and plumbing codes are met.
Specifications
Parameters Default Settings Range
Pump Flow Rates 30 ml/ min. 30 ml or 120 ml / minute
System Modes Relay Mode (STERIS Washers) Signal Mode (HAMO and others)
Cycle Count Pump Pump 2 (Detergent) Pumps 1, 2 , 3 or 4
Units of Measure Metric Standard (U.S.)
Variable Speed Settings 30 ml (10%) / 120 ml (25%) 0 ‐ 100% (40 RPM Max)
Formula Volumes (Signal Mode)
for Non ‐ STERIS Washers
0 ‐ 999 ml 0 ‐ 999 ml or 0 ‐ 99.9 ounces
Formula Delay Times (Signal
Mode) for Non ‐ STERIS Washers
___ 0 ‐ 99 seconds
Pass Code 0000 0000 ‐ 9999
Signal Qualifying Time 3 Seconds 0 ‐ 9 Seconds
Programming Notes:
•
The cycle counter has its own menu to allow resetting back to zero
•
Pass code does not change when clearing all programmed settings
•
To terminate any operation or to exit the programming menus during programming press and hold the enter key.
•
Contact STERIS Technical Support for a temporary AL-1000 pass code should pass code be misplaced or forgotten.
You will need to press and hold the Scroll key to get a three digit number that STERIS Tech support will need to generate a new
pass code for you.