SSDK12M - SSDK16M - SSDK20M
18
Fig.14
Fig.15
Once a start request is made the DSE 3110 will energise the
pre-heat
relay over a period of 10 seconds.
Once the engine is running and all starting timers have expired, the animated icon is displayed.
The DSE 3110 control module is used to start/stop and monitor key elements of the engine and main AC
alternator. Fig.14 show the layout and control buttons.
Then the DSE 3110 will then attempt to crank the engine by operating the starter motor relay and also the
fuel pump relay.
When the engine fires, the starter motor is disengaged. (The DSE 3110 de-energises the starter motor relay
once it detects an output frequency (Hz) from the main alternator).
Timer Icon
(See Fault Finding - DSE 3110)
Engine Running
When the module is controlling the engine (starting and stopping) an animated (rotating) timer icon will be
displayed in the icon area to indicate that a timer is active, for example cranking time, crank rest, stopping
Engine Running
DSE 3110 Control Module - Overview
If the engine fails to fire during this cranking attempt then the starter motor is disengaged for the crank rest
duration after which the next start attempt is made.
Should this sequence continue beyond 3 attempts, the start sequence will be terminated and the
Failed to
Start
icon is displayed on the LCD screen.
Timer Icon
DSE 3110 Operation
Starting Sequence
Engine Speed
Generator Volts (AC)
Generator Frequency
Engine Run Time
Battery Volts (DC)
Page Order
Failed to Start
