49
THOR 103
COD. 6909500060
STEL s.r.l.
– Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
then switches on again automatically.
6.5– CUTTING IN MANUAL MODE
- Turn the switch (7) to manual position ( ).
- Make the cut, when you come out of the piece the arc switches off; to
switch it on again you must press the torch button .
6.6– CONTACT CUTTING
This type of cut is used for materials with thickness 5mm or less.
- Remove the spacer and the 60A TIP. Prepare the torch, fitting the
consumer material for contact cutting: Tip 40A and Deflector (see
page 26 Ref.7).
- Regulate the current from minimum up to 40A (max).
- Make the cut, remaining in contact with the piece to be cut.
Deflector cod 6074400000
Tip 40A cod 6073800000
6.7- SWITCHING OFF
After having made the cut, the operator may switch off the
machine as follows
(refer to figure 1)
:
1-
Switch off the
machine
turning the
line switch (9)
to
position
“0“.
2-
Check that the
machine live Led (1)
and the
air presence Led (2)
are off.
3-
Disconnect the
plug
of the machine from the
power socket
.
4-
Disconnect the cable from the connector (6).
ENGLISH
TECHNICAL
DESCRIPTION
49
THOR 103
COD. 6909500060
STEL s.r.l.
– Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
then switches on again automatically.
6.5– CUTTING IN MANUAL MODE
- Turn the switch (7) to manual position ( ).
- Make the cut, when you come out of the piece the arc switches off; to
switch it on again you must press the torch button .
6.6– CONTACT CUTTING
This type of cut is used for materials with thickness 5mm or less.
- Remove the spacer and the 60A TIP. Prepare the torch, fitting the
consumer material for contact cutting: Tip 40A and Deflector (see
page 26 Ref.7).
- Regulate the current from minimum up to 40A (max).
- Make the cut, remaining in contact with the piece to be cut.
Deflector cod 6074400000
Tip 40A cod 6073800000
6.7- SWITCHING OFF
After having made the cut, the operator may switch off the
machine as follows
(refer to figure 1)
:
1-
Switch off the
machine
turning the
line switch (9)
to
position
“0“.
2-
Check that the
machine live Led (1)
and the
air presence Led (2)
are off.
3-
Disconnect the
plug
of the machine from the
power socket
.
4-
Disconnect the cable from the connector (6).
ENGLISH
TECHNICAL
DESCRIPTION
Summary of Contents for 607510000L
Page 144: ......