14. Arming without transmitters
Press valet switch once, then press and hold it
again for 3 seconds. The siren will chirp once, the
LED will flash rapidly. The system will be armed
after all doors are closed and send the signals to
LCD transmitter. If F24 is on, then the doors will
be locked. This function is only for one operation.
15. Anti-hijack mode
Anti-hijack mode will be activated automatically or
by transmitter (Function F16/F17/F18).
Five anti-hijack modes can be programmed:
1) Anti-hijack off.
2) Active: press and hold transmitter button +
for 3 seconds to activate the anti-hijack function.
3) Full-time: anti-hijack function will be activated
as soon as ignition is turned on.
4) Passive activated with door opened: During
driving, opening the door will activate anti-hijack
function.
5) Passive activated by speed: the pre-set speed
will activate the anti-hijack function.
ACC off can stop alarm temporarily. Once ACC is
turned on, the system will alarm and block the
engine.
Once the anti-hijack mode is activated:
1) In 20 seconds, the anti-hijack icon flashes on
the transmitter, the siren does not chirp.
2) 20 seconds later, the siren will chirp and the
engine will be blocked periodically.
3) 40 seconds later, the siren will chirp with parking
lights flashing rapidly until the car battery is used
up, the engine will be blocked completely.
To deactivate the anti-hijack function:
1) In 40 seconds, press valet switch once.
2) 40 seconds later, to deactivate the anti-hijack
function depends on the setting of F12.
I. F12 is "Valet" - turn ignition OFF/ON and press
valet switch once in 10 seconds.
II. F12 is "Personal code" - enter personal code by
valet switch [24.1].
16. Transponder card (optional)
Please program transponder card into the memory of
the system before use.
3 modes of transponder card can be programmed
(Function F13)
1) F13/1 Transponder card is deactivated.
2) F13/2 Transponder card is activated with engine
block function:
I. Once ignition is turned on, the system starts to
search transponder card in 1 minute. If the system
finds transponder card, the LED indicator flashes
(1 long + 3 short) and the system will send signal
to the LCD transmitter.
If system can not find transponder card in 1 minute,
the engine will be blocked.
If door is opened and stays open, then the system
will delay transponder card searching for 4 minutes.
One more minute later, if transponder card is not
found, the engine will be blocked.
II. To change this protection mode, change F25 for
"door +" or "door -" and connect corresponding
door trigger wire to the footbrake wire.
The following will happen:
*
If door is opened, the system will search
transponder card when the footbrake is pressed.
*
If the footbrake is pressed and transponder card
is not found in 1 minute, engine will be blocked.
*
If door is opened, the system will search
transponder card in 4 minutes when the footbrake
is not pressed.
*
If transponder card is registered successfully with
door closed, pressing footbrake will not activate
transponder card searching, opening door will
activate transponder card searching.
3) F13/3 Transponder card is activated with anti-
hijack function: once ignition is turned on, system
will search transponder card. If system does not
find transponder card in 1 minute it will activate
anti-hijack.
If you place the transponder card in the working
range in 40 seconds when anti-hijack function is
activated, anti-hijack will be stopped.
If you place the transponder card in the working
range after 40 seconds when anti-hijack function
is activated, you need to deactivate anti-hijack, by
valet switch or enter personal code.
17. Valet (service mode)
To activate Valet mode:
Disarm system, turn ignition on for more than 3
seconds then turn off, press the valet switch once
in 5 seconds. The LED will turn on solid. The siren
will chirp once every time when the ignition is turned
off in valet mode.
In valet mode, doors lock/unlock and panic functions
can be operated by transmitter.
To deactivate valet mode:
Turn ignition on for more than 3 seconds then turn
off, press valet switch in 5 seconds.
18. Emergency override
If the transmitter is lost or fails to operate, the system
can be disarmed by using the emergency override
feature. To override the system depends on F12.
F12 -"Valet":
Opening the door with key ( the siren will chirp). Turn
ignition on, press valet switch once in 10 seconds.
F12 -"Personal code":
Enter the personal code [24.1].
If wrong personal code was input three times, you
need to wait for more than 3 minutes to enter personal
code again.
10
11
Summary of Contents for 888W1
Page 1: ......
