F4/1: Doors will not be unlocked when the ignition
turns off.
F4/2: Doors will be unlocked automatically when the
ignition turns off.
During driving, press button or
to lock or unlock
the doors
9. Dome light delay
This function is specifically designed for the vehicle
with dome light function. The system will enter the
arming mode after the dome light turns off. Arming
delay time can be set by F6.
10. Remote panic:
In the event of an emergency (panic) situation, the
siren can be triggered for 30 seconds to attract
attention. Press and hold transmitter button
+
for 2 seconds to activate the panic function:
*
The siren will chirp sharply.
*
The parking lights will flash.
Press and hold transmitter button
+
for 2
seconds or press valet switch (if a personal code is
set, you should enter the personal code) to exit.
11. Time/ alarm time/W-mode setting
Press button + to turn on/off the LCD transmitter's
vibration mode.
Press and hold button for 5 seconds to activate
time /alarm time /W-mode setting mode.
Press button once, the LCD transmitter beeps
once, the hour digit will flash, then press button ,
the flashing icon will change in the sequence below:
time/hour time/minute alarm on/off alarm/hour
alarm/minute W-mode setting exit.
Press "
" to increase (+) or press "
" to
decrease (-).
Press and hold button for 1 second to save and
exit setting.
W-mode: Press +
button together shortly to
turn W-mode on/off. According to F21, CH6 can
be activated.
"W-mode" means the time of transmitter sending
signals to system can be programmed.The "set"
icon will be shown on the LCD transmitter.
12. Low battery indicator
The battery status of the LCD transmitter will be
shown on the LCD display. When the battery
indicator is empty, the transmitter needs to be
charged immediately.
13. Trunk release
Press
or
button to open the trunk. The
shock sensor will bypass when the trunk is opened,
and return to normal when the trunk is closed.
The vehicle must equip with trunk release motor
and select
or
output for trunk release
during installation.
7. Remote sensor bypass
To arm the system and bypass the 1-stage of the
shock sensor: press button , then press button
in 3 seconds, the siren chirps once and the 1-stage
of the shock sensor will be ignored for one cycle.
To arm the system with both sensors bypassed: press
button , then press button
twice in 4 seconds,
the siren chirps twice and both sensors will be ignored
for one cycle.
The operation of remote sensor bypass in mute
arming mode is the same.
8. Central door lock/unlock (F3/F4/F15/F25).
F3/1: Doors will not be locked when ignition turns on.
F3/2: Doors will be locked automatically when ignition
is turned on.
F3/3: If you program F15/2 for speedometer input,
doors will be locked automatically when the car speed
reaches the pre-set speed.
F3/4: If you program F25 for "door +" or "door -", and
connect wires to footbrake signal wires, doors are
locked when the foot brake is pressed.
Note: If one of the doors are not closed properly, the doors
will not be locked.
4. Silent arming/disarming
Press transmitter button
, then press button
or
, the system will arm or disarm without
siren
chirp(s).
5. Mute arming
Press and hold transmitter button for 2 seconds
to arm in mute mode
*
The siren will not chirp for one cycle
*
The parking lights will flash once.
*
The doors will lock.
When the system is triggered, the siren will not chirp.
The LCD transmitter will show as below:
6. Car searching (locating)
Press and hold transmitter button +
for 2
seconds, the siren will chirp and parking lights will
flash 5 times.
8
9
Summary of Contents for 888W1
Page 1: ......
