Page 15 of 38
939504792 Rev D
3
Conference Top Assembly (cont.)
3.
Place worksurface on support structure and column, fitting the support bracket tabs
into the large-diameter holes of the worksurface. Align pilot holes in worksurface
with mounting holes in support structure, and attach rear of worksurface to support
structure with four (4) "A" screws as shown.
4.
Using a leveling tool, level the worksurface by turning the column mounting plate up
or down. Shift the position of the column until the mounting plate aligns with the pilot
holes, and attach with four (4) "A" screws as shown.
5.
Attach wire managers as shown on page 8.
4
5
A
A
A
A
A
See page 8.
