Assemble and Install Roof Vents
!
Place all the parts for both roof vents and handles on a level surface.
Make sure the pieces are in the correct positions before assembling.
Carefully follow the order of assembly to ensure an easy installation.
Wear proper safety gear including work shoes, gloves and goggles.
10.1
10.2A
10.3
Fit panel and profiles L10A and L11A into channels of profiles L12B. Make sure holes in ends
of profiles line up.
!
The roof vents are assembled with the outside face to the ground. ALL VIEWS
ARE SHOWN FROM INSIDE. Assemble BOTH vents first and then add the handles.
IMPORTANT: This greenhouse is equipped with one MANUAL vent handle (S25 installed in step10.3) and one
AUTOMATIC vent handle (auto vent opener installed in step 10.10). The auto vent opener is packed separately.
Remove protective plastic from both sides of panels Y24. Place side to face toward the sun facing
down. Fit panels into channels of profiles L10A and L11A.
L11A
L10A
Y24
L10A
L11A
L10A
L11A
L12B
L12B
Y24
Secure with four
S26 screws.
Attach handle S25 to profile L10A with two S24 screws. NOTE: You will
install the handle to the second vent in step 10.10.
10.2B
L10A
L12B
L11A
L12B
L11A
L10A
L12B
L12B
Y24
S26
S26
S26
S26
L10A
S26
L12B
QTY
Screw
2
#S24
QTY
1
#S25
Handle
L10A
S25
S24
S24
Y24
IMPORTANT: hollow side of handle
S25 faces down when attached.
L12B
S26
L11A
L10A
S24
S24
S25
44 of 55
www.stcny.com
NOTE: ALL VIEWS ARE FROM INSIDE.
Remove protective plastic from EACH side of poly carbonate
panels before installing. Dispose of plastic properly. Install with
side labeled “Face this side towards the sun” FACING DOWN.
!
QTY
Panel
2
#Y24
QTY
QTY
2
#L10A
2
#L11A
Profile
Profile
QTY
4
#L12B
Profile
QTY
Screw
8
#S26