16
· ErgoOne · User Manual
7.2 Maintaining Multi-Channel Pipettes
The figures shown below refer to the 100µl model. They may differ slightly for other
pipette models.
Changing the O rings (100µl and 300µl models only)
O-rings for the pipette cone are removed
and replaced using the optional auxiliary
tool (see section 8 Ordering Information).
Disassembling the lower housing of the pipette
Fig. 9
Fig. 10
– Fully unscrew the lower housing
16
by turning
clockwise (Fig. 9).
– To remove the tip ejector
5
squeeze with
finger and thumb on either side of the tip
ejector, just below the ejector fixing
6
. This
will allow you to slightly lift the ejector fixing
6
which will release the tip ejector
5
.
– Pull both clips
17
down and rotate the lower
housing through 180° (Fig. 10).
