-6-
Operation
DL35-6 and DL35-12
(cig plug version only)
The
DL35-6 and DL35-12
(cig plug version) can be plugged into the
+12VDC cig plug outlet in your vehicle. These units can be turned on and
off using the switch on the cig plug.
The
Pattern Select Button
is
used to set the desired pattern.
You may cycle through the
different patterns by briefly
pressing the Pattern Select Button
and releasing it. The DL35-6 and
DL35-12 have 35 patterns to
choose from. After the final
pattern is reached, the patterns
will cycle through again.
PLEASE NOTE: THIS IS
DIFFERENT THAN THE DL35-6-
1 and DL35-12-1, WHICH CAN
BE PROGRAMMED FOR UP TO
22 DIFFERENT PATTERNS.
If you are installing the DL35-12
and need SAE approval, you
cannot have the Pattern Select
button directly exposed. Enclosed
is a button hole cover (shown to
the right) that can be used to
cover the Pattern Select Button.
When the cover is removed you
can use a screwdriver or other
similar tool to press the button
inside the housing.
If at anytime you would like to go directly to the first pattern
(Warn)
, simply
press and hold the pattern select button for three seconds until the light
blinks once. When the LEDs flash once, release the button and the light will
be in the WARN pattern. If you hold the button down for 6 seconds, the light
will blink once at 3 seconds and then twice at 6 seconds. After it blinks twice,
release the button and the light will be in the default pattern
(Pattern 28: All
Quadflash w/Post Pop, All Doubleflash, All Flicker).
The DL35 lights will remember the pattern they were in when turned off
and display the same pattern when re-activated.
Please review the chart on the next page for the various patterns.
PATTERN
SELECT
BUTTON
PATTERN
SELECT
BUTTON
COVER
DL35-12
Summary of Contents for M-Tech DL35-12
Page 1: ...PLITSTR369 REV C 9 25 06 LED DASH DECK LIGHTS TM ...
Page 20: ... 17 ...
