-14-
(OPERATION CONT’D)
Programming the lights for “Dual Alternating” Flashing
(Use only patterns 11-15)
After you have connected your
wires as described on page 9,
activate the lights and program your
heads as follows:
1. Decide which
Pattern Type
you would like to use:
A
Warn
(SAE and Title 13 compliant)
B
Flicker flash
C
Post pop
D
Psu-flicker
E
Random
2. For each head, hold down the
Pattern Select Button
until the
LEDs blink
twice
(approximately 6 seconds).
This will set the light into
Pattern 11
, which is the
Warn
Pattern
, under the
Alternating
Phase
, 1A.
3. Program the first head: If you
want a
Pattern Type
different
from the
Warn
pattern, press
the
Pattern Select Button
for
1 second and release it to
advance to the next
Pattern
.
Repeat this until you reach the
Phase 1A
pattern you wish to
use (Patterns 11-15). If you
advance past the
Random
Pattern
(pattern 15), return to
Step 2.
4. Once the
Flash Pattern
is set
on the first head, program the
second head in a similar
fashion. The second head
should be programmed
EXACTLY the same as the
first.
5. Once you have the correct
patterns programmed in, you
may turn the lights off. They will remember the programmed pattern and display
that pattern the next time they are activated.
Head 1
(Set in 1A Mode)
Phase 1
Phase 2
Phase 1
Phase 2
DL35-12-1
DL35-6-1
PHASE TYPE: Alternating Mode
2 Complete flash cycles shown
Head 2
(Set in 1A Mode)
Cycle 1
Cycle 2
(* Phase Type refers to each individual head)
TIME
Programming Heads From Warn Pattern
(After holding the button down for 6 sec.)
Pattern Press Button
Press Button
Type
On First Head On Second Head
A
0 Times
0 Times
B
1 Time
1 Time
C
2 Times
2 Times
D
3 Times
3 Times
E
4 Times
4 Times
Summary of Contents for M-Tech DL35-12
Page 1: ...PLITSTR369 REV C 9 25 06 LED DASH DECK LIGHTS TM ...
Page 20: ... 17 ...
