-7-
Control Head Cover Removal
•
Remove the three Philip head screws recessed in the
back of the hand held controller.
•
CAREFULLY remove rear cover using caution so as not to
lift circuit board and membrane switch away from front
faceplate.
•
Locate the 10 jumpers located near the microphone coil
cord strain relief.
•
DO NOT REMOVE ANY OF THE FIVE JUMPERS ON THE RIGHT
SIDE !!!
•
By default, the five jumpers on the left side come installed
across both pins.
(Installer Selectable Options CONT’D)
Jumper Controlled Options
To change any of these options, move
the corresponding jumper from both
pins to only the top pin as shown in the
diagram to the left.
•
Audible Beep Disable
•
S4=S3+S2+S1 (LCS880 only)
•
S3 Momentary
•
S4 Timer
•
Auxiliary Control
If you are NOT changing any of the options described on the
previous page, skip this section.
