-9-
Mounting
SAFETY PRECAUTIONS
For the safety of the installer, vehicle operator, passengers, and the community
please observe the following safety precautions.
Failure to follow all safety
precautions and instructions may result in property damage, injury or death.
DO NOT mount in air bag deployment area.
Devices should be mounted only in locations listed in SAE standard J1849.
Controls should be placed within convenient reach of the driver.
Assure clearances before drilling in vehicle.
Sound levels produced by attached speakers can cause permanent hearing loss.
Never operate this unit without adequate hearing protection for you and others in
the area.
(OSHA 1910.95)
SIREN AMPLIFIER & RELAY CONTROL BOX
•
The amplifier should be mounted in a location such as the driver compartment
firewall, under the seat, or in the trunk.
•
Do not mount the amplifier in the engine compartment or in an area that would
be allowed direct exposure to weather elements.
•
Choose a mounting location away from any air
bag deployment areas.
•
Assure adequate ventilation to prevent
overheating.
Mount the amplifier unit through the
four 1/4” holes located in the flanges
(two visible and two not shown in the
picture to the right).
CRADLE MOUNTING
•
The LCS880 and LCS881 both include a cradle for
storing the hand-held controller when it is not in use.
•
Select a location so that the cable does not interfere
with the vision of the driver or the operation of any
controls, including, but not limited to, the steering
wheel, gear shifter, and/or airbag.
•
The cradle comes with four mounting holes predrilled
in it. Only two screws are normally necessary to
secure the cradle to the dash. Once you have
selected a location, use the cradle as a template
and mark the two mounting holes you will be using.
•
Carefully drill two 1/16" pilot holes for your screws. Be
sure to check for wiring and/or any other obstructions
behind the mounting hole locations.
•
Once the holes are drilled, use the two self-tapping
Phillip head screws to secure your cradle.
