-23-
Operation
SLIDE SWITCH
The slide switch is designed for quick pursuit
mode operation. The far left position (OFF) will
not activate any outputs.
Position 1:
Activates the first set of lights
(connected to L1).
Position 2:
Activates both the 1st and 2nd set
of lights (connected to L1 and L2).
Position 1 & 2:
(LCS881 only)
If you have the 1
st
jumper in the Arrow Stick Light
Controller set for Phantom Mode
-
(see page19)
, the end lights in
your traffic director will flash in a
high speed “Warn” pattern in both
positions 1 and 2.
Position 3
: Generally used for the
FULL PURSUIT MODE
. It allows for quick
activation of both the lights and the siren in one motion. When the
slide switch is moved to
Position 3
, the following will activate:
•
All three sets of lights (connected to L1, L2, and L3)
•
The siren (WAIL mode)
•
All of the Traffic Director lights will flash in a “WARN” pattern
(LCS881 only)
Note:
The auto-activation of the siren and the arrow stick may be
disabled if desired.
(Refer to the
Pursuit Disable
section on page 5)
.
GENERAL
This unit is designed for easy operation under
the stress associated with high-speed pursuit.
Many light and siren functions are accessible
with one simple motion of the slide switch.
POWER
The unit is turned On and Off by a recessed
switch on the side of the hand held
controller. All functions are disabled until
the unit is switched on.
PUSH BUTTON SWITCHES
S1, S2, S3, and S4 control the devices connected to the corresponding output
terminals described on pages 16-17. Press once to activate, then press again to
deactivate.
Optionally, S3 can be set to be a momentary switch, S4 can be set as a timed “Gun
Lock” button, or S4 can be set to activate S1, S2, and S3 concurrently
(see
Control
Head Option Jumpers
on pages 6-8)
.
