Stanley STSC1618, Manual

Page: 11 / 44

11
ENGLISH
(Original instructions)
• Tighten the locking knob.
Removing
• Loosen the locking knob.
• Pull the rip fence out of the tool. Note: If you do not have
a proper fitting fence, use a straight edge guide in
contact with the edge of the shoe to improve accuracy of
cut and reduce the possibility of binding and kickback.
Mounting the Dust Extraction Spout
(fig. E, F, N)
Your circular saw is supplied with a dust extraction spout.
TO INSTALL DUST EXTRACTION SPOUT (FIG. N)
1. Fully loosen depth adjustment lever (Fig. F, 12).
2. Place base plate (Fig. a, 4) in the lowest position.
3. Align the two halves of the dust extraction spout (22) over
upper blade guard (23) as shown.
4. Insert screws and tighten securely.
Accessories
The performance of your tool depends on the accessory
used. Stanley and Piranha accessories are engineered to
high quality standards and designed to enhance the
performance of your tool. By using these accessories you
will get the very best from your tool.
Warning! The use of any accessory not
recommended for use with this tool could be
hazardous. Use only 185mm blades with 19mm
or 20mm diameter arbor.
Maintenance
Your tool has been designed to operate over a long period
of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
Warning! Before performing any maintenance,
switch off and unplug the tool.
• Regularly clean the ventilation slots in your tool using a
soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Important! To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be
performed by authorized service centers or other
qualified service personnel, always using identical
replacement parts.
Lubrication
Stanley tools are properly lubricated at the factory and are
ready for use.
Dust Extraction (fig. O)
WARNING: Risk of dust inhalation.
To reduce the risk of personal injury,
ALWAYS wear an approved dust mask.
A dust extraction spout (22) is supplied with your tool.
Vacuum hoses of most common vacuum extractors
will fit directly into the dust extraction spout.
WARNING: ALWAYS use a vacuum
extractor designed in compliance with
the applicable directives regarding dust
emission when sawing wood. Vacuum
hoses of most common vacuum
cleaners will fit directly into the dust
extraction outlet.