Stanley MA900n, Installation And Owner'S Manual

Page: 13 / 36

© 2005, The STANLEY WORKS. ALL RIGHTS RESERVED.
203936 Rev. C
MA900 Installation Manual
11
Inswing Door – Mounting Preparation
Fig. 10
Template alignment, inswing door
1. Make sure that proper additional support is installed as
shown in Fig. 6.
2. Select the right hand or left hand side of the installation
template.
3. Position the template (see Fig. 10).
• Align the indicated horizontal line on the template with
the top edge of the door frame.
• Align the indicated vertical line on the template with the
centerline of the hinge.
• Use tape to hold the template in position.
4. Verify that the template is aligned properly; reposition
if necessary.
5. Use a center punch to make a small depression at the center
of each of the hole locations marked “A,” “B,” and “D” on
the template.
6. If electrical wire is to be run through the back of the header,
use a center punch to make a small depression at the center
of the hole location marked “C” on the template.
7. Remove the template.
8. Use a 1/8” bit to drill a pilot hole at each of the two hole
locations marked “D” on the template.
9. Drill the header mounting holes marked “A” and “B” to the
desired size for mounting hardware (not supplied).
10. Install two mounting screws into lower left and lower right
hand mounting holes and tighten about halfway.
11. If electrical wire is to be run through the back of the header
drill the hole location marked “C” on the template to the
desired size for wire.
The hole for the wire must be free of burrs and
rough edges.
Install Header Assembly
1. Install the header assembly over the two screws, then slide it
sideways so that the screw occupies the smaller part of the
opening (see Fig. 11).
Fig. 11
Header mounting
2. Tighten the two screws so that they are snug but not fully tight.
3. Install the remaining four screws and 1/4” lock washers so
that they are snug but not fully tight.
4. Fully tighten all mounting screws.