Stamina CoreTraining Inversion System, Owner'S Manual

Page: 8 / 22

ASSEMBLY INSTRUCTIONS
8
STEP 7
Attach the
SLIDER SUPPORT(11)
onto the Bracket on the
CROSSING FRAME(6)
with
BUTTON
HEAD BOLT(M10 x 90mm)(62), NYLOCK NUT(M10)(65),
and
WASHER(M10)(68).
STEP 8
Straighten the
CABLE(35)
on the
LEVER(36).
Refer to the Inset drawing. The
LEVER(36)
should be
attached 4.5 inches lower than the shaft on the
LEFT PIVOT ARM(7).
To attach the
LEVER(36)
onto the
LEFT PIVOT ARM(7),
hook the
CLIP(37)
into slot in the
LEVER(36)
and secure the
LEVER(36)
in
position with
ROUND HEAD SCREW(M5 x 18mm)(38), WASHER(M5)(39),
and
ACORN NUT(M5)
(40).
STEP 9
Grasp the
LEVER(36)
and then Insert the
BACK SUPPORT BAR(10)
into the
SLIDER SUPPORT(11).
Release the
LEVER(36)
to lock the
BACK SUPPORT BAR(10)
in one of the adjustment holes. Swing
the
BACK FRAME(9)
to aline the Bracket on the
BACK FRAME(9)
with the Bushings on the top of the
BACK SUPPORT BAR(10),
then secure with
BUTTON HEAD BOLT(M10 x 90mm)(62), NYLOCK
NUT(M10)(65),
and
WASHER(M10)(68).