Place the
CPS 9190 Indoor Cycle
in the area where it will be used. It is recommended that the
CPS 9190
Indoor Cycle
be placed on an equipment mat. The
CPS 9190 Indoor Cycle
is approximately 50 inches
long (max.) x 18 3/8 inches wide x 42 5/8 inches tall (max.). An area 4 feet wide x 6 feet long is required
for safe operation of the
CPS 9190 Indoor Cycle.
Make sure that adequate space is available for access
to and passage around the
CPS 9190 Indoor Cycle.
LEVELING:
Adjust the
STANDS(51)
under the
FRONT
and
REAR STABILIZER(3, 4)
so that the
CPS
9190 Indoor Cycle
sits on the floor without rocking. Refer to the instructions below the
illustration.
MOVING:
The
CPS 9190 Indoor Cycle
has a pair of
WHEELS(49)
on the
FRONT STABILIZER(3).
Lift up the
REAR STABILIZER(4)
to move the
CPS 9190 Indoor Cycle.
CAUTION:
Locate and read the
WARNING LABEL(70)
on the
CPS 9190 Indoor Cycle.
Make sure that
all users read the
WARNING LABEL(70).
SET UP INSTRUCTIONS
9
FUNCTION INSPECTION:
Visually inspect the
CPS 9190 Indoor Cycle
to verify that assembly is as shown in the above illustration.
Check the function of the
CPS 9190 Indoor Cycle
by turning the crank slowly through one complete
revolution to verify that the drive train functions properly. Adjust the
TENSION KNOB(34)
to verify that the
adjustable tension is working properly.
Loosen the
NUTS(M8x1.25)(67)
until they
touch the
STANDS(51)
. Adjust the
STANDS(51)
for leveling. Tighten the
NUTS(M8x1.25)(67)
securely against the
STABILIZERS(3, 4)
to lock
the
STANDS(51)
in position.
Equipment Mat
