ST STM32F10 Series, Application Note

Page: 17 / 23

AN2586 - Application note Debug management
17/23
4 Debug management
4.1 Introduction
The Host/Target interface is the hardware equipment that connects the host to the
application board. This interface is made of three components: a hardware debug tool, a
JTAG or SW connector and a cable connecting the host to the debug tool.
Figure 12 shows the connection of the host to the STM3210B-EVAL board.
Figure 12. Host-to-board connection
4.2 SWJ debug port (serial wire and JTAG)
The STM32F10xxx core integrates the serial wire / JTAG debug port (SWJ-DP). It is an
ARM® standard CoreSight™ debug port that combines a JTAG-DP (5-pin) interface and a
SW-DP (2-pin) interface.
●
The JTAG debug port (JTAG-DP) provides a 5-pin standard JTAG interface to the AHP-
AP port
●
The serial wire debug port (SW-DP) provides a 2-pin (clock + data) interface to the
AHP-AP port
In the SWJ-DP, the two JTAG pins of the SW-DP are multiplexed with some of the five JTAG
pins of the JTAG-DP.
4.3 Pinout and debug port pins
The STM32F10xxx MCU is offered in various packages with different numbers of available
pins. As a result, some functionality related to the pin availability may differ from one
package to another.
4.3.1 SWJ debug port pins
Five pins are used as outputs for the SWJ-DP as alternate functions of general-purpose
I/Os (GPIOs). These pins, shown in
Table 2 , are available on all packages.
STM3210B-EVAL
Host PC
Power supply
JTAG/SW connector
Debug tool
ai14374