Element-P
50
12.
Are there Cycle Time adjustments on the Control Board for different types of fuel?
Answer: There are 4 individual programs on the control board; each
has a different Cycle time.
The Element-P only uses Program 3 and
Program 4
Your Element-P has been factory set to Program 3. When
programming the control board, you will see LED light flash, as
shown in the figure to the right. The LED lights flash in the following
manner:
1 -
Program 1.
The Cycle Time is 11.5 seconds. THIS PROGRAM IS
ONLY TO BE USED WITH THE ELEMENT-MF MODEL.
(DO
NOT USE THIS PROGRAM WITH THE ELEMENT-P).
2 -
Program 2.
The Cycle Time is 13 seconds. THIS PROGRAM IS
ONLY TO BE USED WITH THE ELEMENT-MF MODEL.
(DO
NOT USE THIS PROGRAM WITH THE ELEMENT-P).
3 -
Program 3.
The Cycle Time is 11.5 seconds.
THIS IS THE
DEFAULT PROGRAM FOR USE WITH THE ELEMENT-P.
This program is for use with
Pellets, Cherry Pits and a 50/50
Percent Mixture of Pellets and Corn
.
4 -
Program 4.
The Cycle Time is 10 seconds.
This Program offers
Self-Ignition and is only for units that have the Versa Grate
system & Igniter installed
. This program is for use with
Cherry
Pits only
.
13.
How do I change to a different Program on the control
board?
First the Stove must be turned off and cooled down.
Step 1 - The Thermostat switch must be in the
Manual
position.
Step 2 – Press and hold the
Auger Feed
Button.
Step 3 – Press the
Trim High and Low
Buttons at the same time.
Release all 3 buttons simultaneously.
Step 4 – Observe the LED light flashing according to the Program
chosen. Program 1 flashes once, Program 2 flashes twice, Program 3
flashes three times and Program 4 flashes 4 times.
Changing the Cycle Time will change the BTU Input of the Stove. The
longer the Cycle time the lower the BTU rating.
Figure 32
Figure 33
Summary of Contents for Element-P
