Ashby-P Insert
Page 29
The Cycle time is the total of the ON Time & OFF Time added together. The ON Times are
constant, so this means that the OFF Time is increased or decreased, depending on the program
chosen.
Program 1.
The Cycle Time is 11.5 seconds. This program is only to be used with the Ashby-
MF model.
(DO NOT USE THIS PROGRAM WITH THE ASHBY-P).
Program 2.
The Cycle Time is 13 seconds. This program is only to be used with the Ashby-MF
model.
(DO NOT USE THIS PROGRAM WITH THE ASHBY-P).
Program 3.
The Cycle Time is 11.5 seconds.
This Program offers Self-Ignition and is only for
units that have the Versa Grate system & Igniter installed. This program is the default program
for use with the Ashby-P and is for use with
PFI Premium
Pellets
.
(DO NOT USE THIS
PROGRAM WITH THE ASHBY-MF).
Program 4.
The Cycle Time is 10 seconds. This Program offers Self-Ignition and is only for
units that have the Versa Grate system & Igniter installed and is for use with
PFI Premium
Pellets
.
(DO NOT USE THIS PROGRAM WITH THE ASHBY-MF).
Program 4 is for adjusting for variations that occur with PFI Premium Pellets. Ask your dealer
before using this Program in your unit. See page 25 for more information on variations between
different brands of pellets.
Changing the program on the Control Board
To change the Program the Insert must be in the OFF
position, the unit must be completely cooled down so the
Proof of Fire Switch is Open and the Thermostat slide switch
must be in the Manual mode.
(See figure 17)
Press & hold
the Auger Feed Button, then press the Trim
High & Low
Button at the same time. The LED lights
that indicate the heat level will flash. The number of
times the lights Flash will indicate which program is
running.
Program 1 – LED lights flash
once
Program 2 – LED lights flash
twice
Program 3 –LED lights flash
three times
Program 4 – LED lights flash
four times
Figure 17
Lighting Your Ashby-P
Danger: Risk of Fire or Explosion - Do not burn Garbage, Gasoline, Drain Oil or other
Flammable Liquids.