SST Automation GT200-HT-RS, User Manual

Page: 7 / 52

WWW.SSTCOMM.COM 7
3. Click “HartChannel0” in the tree view on the left, the configuration table is shown on the right as below:
Note: HART protocol specifies that the slave device which address is 0 must work in single-point mode. In
single-point mode the digital communication and analog communication is allowed to exist at the same time. The
Slave with address 1~15 works in multi-point mode. In multi-point mode the analog output of the device is the
minimum value (e.g. 4mA), only allows digital communication. The protocol also specifies that the default factory
address of field device is 0.
4
．
Right-click HartChannel0, in the pop-up menu, select “Add Node”, as shown below:
5
．
Right-click “Node(0)”, in the pop-up menu selects “Add Command” to add a command (Command ID1) in
the dialog box, and then click OK to return.