29
8 DoorCom
DCA 740-01
The DoorCom Analog DCA 740-...
is used as an interface between
DoorCom IP and an analog
telephone connection of a
telecommunication system.
To each IWA- or client address a
call number can be assigned. The
functionality depends in the main
on the capability of the telephone
system / on the telephones
connected to it.
The assignment and functionality
can be programmed in the
SIVS 610-...
The selection of users and control
and switching functions takes place
by means of DTMF dialling. The
telecommunications system and
the connected telephones must
therefore possess DTMF dialling
capability.
Functional characteristics
The PBX extension of the telephone
system must operate using the
dual tone multiple-frequency
(DTMF) dialling method. It is of no
consequence whether the telephone
system is an ISDN or analogue
installation. After pressing the call
button, the DCA 740-... dials the
previously in the SIVS programmed
call number; a telephone connected
to the telephone system rings.
After picking up the receiver, the
active door call is superposed /
signalled. By pressing a numerical
button (0-9) at the telephone, it is
possible to speak to the visitor (this
function can be switched off). If the
number #61 is pressed, the door
release is actuated for 3 seconds.
(For connection of more than one
telephone, a so-called group call
or collective call function must be
set up in the telephone system. For
details, ask the telephone system
installer).
Power supply
The DCA 740-... is supplied directly
from the SIVS 610-...
A separate supply is consequently
not required. The power to the a/b
public network interface is supplied
9 DoorCom IP
Factory setting IPVS 600-...
With the reset button at the
IPVS 600-..., it can be reset to the
as-delivered status. It is essential to
load the Siedle factory configuration
in the IPVS 600-... after a reset.
Proceed as follows.
1
Open the Internet Explorer.
2
Access the video server (IPVS) with
its IP address
3
Access the following menus in
sequence:
Setting
Service parameters
Firmware and configuration upload
4
Under Configuration upload,
select the configuration file with
„search...“
The file is on the supplied CD.
5
Select the file with the rtc_image
with upload.
Using the Upload button, start the
update.
from the telecommunication
system or the a/b public network
connection from the exchange. It is
not possible to connect an individual
public network telephone directly to
the a/b line of the DCA 740.
Handling
DTMF dialling
Function
0 - 9
door call
acceptance
#0
terminate
connection
#50
light
#51 -#59
System- Control
function 1-9
#61
door release
