4. Freepour Chiller
Freepour Chiller
l
21
20
l
FreePour ChiLLer
Changing settings that relate to the operation of
the Chiller is performed through the electronic
controller.
The electronic controller is visible through a cut
out in the front panel. It controls and displays
the cabinet interior temperature and signals
temperature alarms. It uses temperature probes
around different areas of the refrigeration system
to collect data and to run the cabinet accordingly.
The electronic controller is pre-programmed
and requires no initial setup or additional
programming. We do not recommend that
the settings be changed unless it is absolutely
necessary.
CAreL eAsy eLeCtroniC ControLLer
Because the electronic controller plays such an
important role, it’s helpful to know the parts of
the faceplate you may use.
1. Compressor Indicator
2. Display
3. Stand-by (up) button
4. Mute (set) button
5. Manual defrost button
NOTE: See the table on page 21 for the function of
each item above.
stAnd-by Mode
Press and hold the stand-by button for three
seconds to turn stand-by mode on or off. When
stand-by mode is on, the controller display will
alternate between the cabinet temperature and
Of,
and the compressor, fans and alarms are
disabled.
The interior light is still activated by the door
switch and will come on when a door is opened.
teMPerAture setPoint
The temperature setpoint is factory set and can be
adjusted if necessary.
We do not recommend that the setpoint be
changed unless it is absolutely necessary, and
then only by small increments at a time.
To view and adjust the temperature setpoint:
1. Press and hold the
set
button until the
controller display shows
SEt
followed by a
temperature value. The temperature value is
the current setpoint.
NOTE: If
PS
appears on the display, the set button
has been held for to long. Release it, then press the
set
button twice to restart the procedure.
2. Press the
up
and
down
buttons to adjust the
value to the required setpoint.
3. Press the
set
button again to store the new
setpoint value.
Carel Easy - Icons and Functions
Item
Icon
Function
1
Compressor indicator
ON when the compressor and condenser fan starts.
Flashes when activation of the compressor is temporarily delayed.
2
display
Shows the cabinet temperature.
Flashes when the door is open.
3
stand-by (up) button
Turns stand-by mode on and off.
To scroll settings up (in program mode).
Note: This is not an isolation switch.
4
Mute (set) button
Mutes the audible alarm (buzzer) and deactivates the alarm relay, and used in
program mode.
5
Manual defrost button
Press for more than 5 seconds to initiate manual defrost.
To scroll settings down (in program mode).
Carel Easy - Messages and Alarms
Code
Alarm
Action
Defrost cycle in
progress message
Cabinet is running correctly.
Message will stop displaying once the defrost cycle is complete.
Temperature sensor
fault alarm
Reset alarm by unplugging the cabinet from the power supply
for one minute, then reconnect.
If alarm persists, arrange a service call.
Product low
temperature alarm
Product high
temperature alarm
Parameter error alarm
Defrost error alarm
1
2
3
5
4
Summary of Contents for Freepour
Page 16: ......
