SS Telecoms SS-76 NG, User Manual

Page: 18 / 19

SS-76 NG USER MANUAL
DOC. NO: SS-76 NG (REVISION 05) Page 18 of 19
CODE: hhhh
Where hhhh is a 16 bit number presented in hexadecimal format. „hhhh‟ is the
CRC-1021 result calculated using the Secret Code and the challenge as a
message. The challenger produces a random challenge message and sends this to
the SS-77 and at the same time calculates the expected response. The challenger
then waits for the response from the SS-77 and if it matches its internal calculation
then it can be satisfied that the buffer is authentic.
~ <aa><cc>
This command (tilde space) is used to set the characters of the Secret Code. The
secret code can be up to 16 characters in length. „aa‟ is the character index from
„00‟ to „0F‟ (total 16). „cc‟ is the character code and can be any hexadecimal value
other then „FF‟. The value „FF‟ is reserved as the „end‟ code and as the „blank‟
code. The Secret Code characters can only be set if they are „FF‟.
11
QUICK SETUP GUIDES
11.1 ASCII DATA COLLECTION VIA SERIAL PORT
Configuring serial port 2 as PABX Logging port

XLT ASC (Sets the Protocol translation ASCII)

SDL 2 (Sets the default logging port to serial 2)

SB 2 9600 (Sets the baud rate to 9600)
11.2 DATA COLLECTION ON ALCATEL 4400 / OMNI PCX
Configure IP on the Ethernet interface

UDH 1 (This will enable the buffer to use DHCP)
Or
Configuring the buffer to use a static IP

UDH 0 (To disable DHCP)

LI <IP Address of Buffer> (Assigns a Static IP Address to the Buffer)

SM <Subnet Mask>

GA <Gateway> (Sets the default gateway)

DNS <DNS Server>
Use the following settings for Alcatel 4400 / Omni PCX

XLT ALC (Sets the Protocol translation to Alcatel 4400 PABX)

ALI <PABX IP Address> (To set the PABX IP)
11.3 DATA RETRIEVAL USING UDP LOGGER
Configuring the buffer to connect to UDP Logger

TMI sstelecoms.pointclark.net (IP address or FQDN of the UDP server)

TMP 1122 (The UDP Logger port)

BID SS0005A4 (Sets the buffer ID as used by UdpLog)

APN Internet

GAG Off