SS Telecoms SS-76 NG, User Manual

Page: 17 / 19

SS-76 NG USER MANUAL
DOC. NO: SS-76 NG (REVISION 05) Page 17 of 19
8.8 FTP SERVER
FTP SERVER COMMANDS
The SS-76NG waits for the PABX to log in. The PABX needs to use the username and password
set.
Command Description
FTU <username> Sets the FTP Username. Maximum 12 characters.
FTP <password> Sets the FTP password for Username. Maximum 12 characters.
9 REMOTE ACCESS TO SERIAL CONNECTED EQUIPMENT
9.1 DIRECT
This command instructs the buffer to route the logging port to the MMI port. This
provides direct access to the device being logged so that setup and diagnostics can
be undertaken remotely.
There are a few configurations, but essentially the target being logged should be a
serial port device. Thus it is possible to connect DIRECT to Serial 1 or Serial 2,
whichever is the default logging port.
DIRECT from serial the MMI serial port will copy characters from the MMI serial
port to the Logging Serial port and vice versa.
DIRECT from a TCP/IP connection on socket 0 will copy characters from the
Network Connection to the Logging Serial port and vice versa.
To use DIRECT from UdpLog, a chat session first needs to be established. The
command DIRECT must be issued. Once DIRECT mode has been entered it will
exit due to activity timeout. To prevent indeterminate DIRECT operation a UDP
packet must be received to prevent the timeout.
9.2 SETUPMODE
This command instructs the buffer to enter remote setup mode from a UDP
session. Normally this will take place during an UdpL
og „chat‟ session. When the
SETUPMODE has been entered all the normal MMI commands can be executed.
The command will timeout after 2 minutes of inactivity.
10 DONGLE OPERATION
CODE<abc…nmo>
This is the challenge of the Challenge-Response dongle mode of operation. Note:
T
here is no space between the command „CODE‟ and the random challenge code.
The response will be: